Velvet Embossing Tutorial

So far, I've only tested this method on rayon/acetate velvet.
Items needed:
velvet
iron
spray bottle
rubber stamp



Look for stamps that have clear designs with nothing too horribly detailed. I honestly didn't think these key designs would turn out, but they did wonderfully. As with everything, test on a small scrap of fabric before really going after it.

Rubber stamps are best. I haven't used acrylic stamps, but I've read they can distort or melt under high heat. Unmounted stamps can be a cheaper alternative and easier to iron on.

Place the velvet, flock or fuzzy part face down, on the stamp. Wiggle the fabric over the top a bit to settle it into place. Pinning the fabric to your ironing board can help keep it steady. I generally use a high heat on my iron, but not all irons have the exact same heat output. Test, test, test!




Using a spray bottle, soak the velvet over the stamp thoroughly. The water tends to bead up over the back of the fabric, so use your finger to smooth it out if necessary.






Iron until the water steams completely away over the stamped area. You should be able to see an impression of the stamp as the fibers compress on the underside.